16
Garrett Metal Detectors
BATTERY REPLACEMENT
The PRO-POINTER's battery condition is
continually monitored automatically. When the battery
is becoming low, the detector will sound an alternating
dual-tone alarm. Replace the 9V battery as soon as
possible by unscrewing the battery cover and tilting the
detector so the battery slides out. Replace with a new
9V battery and hand-tighten the battery cover.
The battery compartment is keyed to only accept
battery contact in the proper position. If a 9V battery
is improperly installed, no circuitry damage will occur.
However, it is important to observe the polarity of the
battery and the PRO-POINTER battery compartment
to ensure operation. Never force the cover to close.
Remove the battery when the PRO-POINTER is to
be stored for more than 30 days.
Note:
Do not affix metallic labels (or any material that
might cause the detector to alarm) to the detection
area of the PRO-POINTER. Doing so might cause an
imbalance within the detection field and thereby reduce
scanning effectiveness.
1532600 PP Manual.indd 16 7/29/2008 9:11:29 AM
To Next Page
Loading...
