OPERATING INSTRUCTIONS
Switch the detector on by pressing the power
button while holding the detector away from any
metallic objects. To avoid cancelling out the target, do
not turn on the PRO-POINTER while it is adjacent to
the target.
The white LED Light will illuminate when the PRO-
POINTER is on and this light will remain on until the
power button is pressed again to switch off the unit.
This mini flashlight feature is useful when operating in
low light situations.
The PRO-POINTER is a non-motion, all-metal
detector. This enables you to remain stationary over a
target with continuous audio and vibration response.
As the PRO-POINTER is moved in closer proximity to a
metallic target, the rate of pulsing audio and vibrations
increase proportionally—allowing precise pinpointing
of the target.
Operation is completely automatic. All metals will
be detected including ferrous and non-ferrous.
Basic Recovery Method: Once you have
located a target with your ground search metal detector,
dig the recovery hole or remove the plug of earth.
1532600 PP Manual.indd 8 7/29/2008 9:11:27 AM
To Next Page
Loading...
Need help?
General
