EasyManua.ls Logo

Gateway 400 - Activating and using Hibernate mode

Gateway 400
278 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
125
Changing the battery
www.gateway.com
Changing the battery
If your notebook is plugged into an AC outlet, you can change the battery while
the notebook is turned on. If your notebook is not plugged into an AC outlet,
you must turn the notebook off while changing the battery.
Replacing the battery
To replace the battery:
1 If your notebook is on and is plugged into an AC outlet, go to Step 2.
-OR-
If your notebook is on and is not plugged into an AC outlet, save your
work and turn off the notebook.
2 Close the LCD panel.
3 Turn your notebook over so that the bottom is facing up.
Warning Danger of explosion if battery is incorrectly replaced.
Replace only with a Gateway 400SD4 battery. Discard
used batteries according to the manufacturers
instructions.
The battery used in this device may present a fire or
chemical burn hazard if mishandled. Do not disassemble,
heat above 212°F (100°C), or incinerate. Dispose of used
battery promptly. Keep away from children.

Table of Contents

Other manuals for Gateway 400

Related product manuals