214
Chapter 15: Upgrading Your Notebook
www.gateway.com
8 Hold the new or replacement module at a 30-degree angle and press it into
the empty memory slot. This module is keyed so that it can only be inserted
in one direction. If the module does not fit, make sure that the notch in
the module lines up with the tab in the memory bay.
9 Gently push the module down until it clicks in place.
10 Replace the memory bay cover and tighten the cover screw.
11 Insert the battery, then turn your notebook over.
12 Connect the power adapter and modem and network cables, then turn on
your notebook.
Important Use only memory modules designed for the
Gateway 400SD4.
To Next Page
Loading...
