GBF PL960 Series - Add User Access Codes; Delete User Access Codes; Delete User Access Codes Directly; Setting the Length of the Access Codes and Programming

5.4 Add User Access Codes:
1. Enter programming mode.
2. Enter two digits (01 – 40) representing the slot in which the user
code will reside, a longer beep is heard.
3. Enter the new user code (length determined through other
programming); another longer beep will indicate the new code was
stored successfully.
4. Press ‘ ’ to exit the programming mode.
*Note: Slots 31 – 40 are toggle-on/toggle-off code slots. Using a code
programmed in one of these slots will hold the unlock relay in it’s
activated state until the same code is entered again.
5.5 Delete User Access Codes:
1. Enter programming mode.
2. Enter two digits (01 – 40) representing the slot containing the access
code you want to delete. A longer beep is heard.
3. Press the ‘#’ button, another longer beep is heard confirming the deletion.
4. Press ‘*’ to exit the programming mode.
5.6 Delete User Access Codes Directly:
1. Enter programming mode.
2. Press ‘#’, two short chirps are heard.
3. Enter the access code you want to be deleted, a longer beep is heard
confirming deletion of the access code.
4. Press ‘ ’ to exit the programming mode.
5.7 Setting the Length of the Access Codes and Programming
Password:
1. Enter the programming mode.
2. Press ‘99’, a longer beep is heard.
3. Enter a single digit (2 – 6) representing the desired length of the access
codes and programming password, and a longer beep is heard confirming
the change.
4. Press ‘ ’ to exit the programming mode.
Note: The programming password will need to be reset using section 5.1.
*
*
*
- 24 -