GBF PL960 Series - Delete All Settings (Maintains Programming Password)26; Factory Default (Keypad Settings Only)

Password):
1. Enter programming mode.
2. Press ‘#’, two short chirps can be heard.
3. Press’#’ again, a longer beep can be heard.
4. Press ‘#' again seven more times. After three seconds another
5. Press’*’ to exit the programming mode.
5.9 Factory Reset (Custom Keypad Settings Only):
1. Disconnect power to the IP Doorbell.
2. Restore the power to the IP Doorbell. Two short chirps will be
heard.
3. Within 3 seconds, press the '#’ button. A longer beep is heard,
indicating the keypad programming has been restored to factory
default settings.
GBF Electronics Inc
110A-12811 Clark Place
Richmond, BC
Canada, V6H 2H9
Tel: 604-278-6896
or 604-285-8721
Fax: 604-278-6895
info@gbfelectronics.com
Be sure to check our website support section for video tutorials.
longer beep will be heard confirming deletion of all User codes
and resetting the unlock duration time back to 1 second.
Programming password and length will remain unchanged.
5.8 Delete All Settings (Maintains Programming
- 25 -