Appendix B: (cont.)
4. Enter the ‘User Name’ (default is ‘admin’).
5. Enter the ‘Password’ (default is ‘1234’).
6. Click ‘Login’.
7. Click ‘Config’ tab.
8. Expand ‘Network Settings’.
9. Click ‘Wireless’.
10. Depending on the build version of your IP Doorbell, you will either click
‘Close’, or choose ‘WLAN Mode’ from the pull-down menu (currently shows
AP Mode).
11. Click ‘OK’ to save the setting and restart the IP Doorbell. After the IP
Doorbell finishes it’s reset (just after the illuminator LED’s flash, about 1
minute), log back in to the Web Browser Interface again.
12. Click ‘Config’ tab.
13. Expand ‘Network Settings’.
14. Click ‘LAN’.
15. Ensure that the Gateway and Preferred DNS IP addresses match the IP
address of your router. If they do not match, ensure that the ‘DHCP Enable’
box is checked, click ’Save’, and let the IP Doorbell reset again.
The IP Doorbell SSID should no longer be available in the list of available
WiFi networks viewable from your mobile device.
- 33 -
To Next Page
Loading...
