How to troubleshoot a GCC Technologies P3-132S that doesn't operate?
If your GCC Technologies Plotter isn't operating, try switching it off and then on again. If the problem continues after rebooting, contact a technician from your dealer.
What to do if my GCC Technologies Plotter shows a communication error?
If you're getting a communication error with your GCC Technologies Plotter, try testing the communication between your plotter and computer. If issues persist, have your cutting plotter serviced.
What to do if GCC Technologies P3-132S cutting exceeds the cutting limit?
If your GCC Technologies Plotter displays a message indicating that the cutting exceeds the limit, reload larger media or rescale the plot to a smaller size. Then, press the key followed by the display of LCM to continue.
How to fix a GCC Technologies Plotter with a dull blade?
If the blade of your GCC Technologies Plotter is dull or chipped, replace it with a new one.
What to do if GCC Technologies Plotter shows a problem on the X axis?
If your GCC Technologies Plotter displays a message indicating a problem on the X axis, check if the drum is working well and if the media is loaded correctly. Correct any issues and re-power the plotter to reboot the system.
What to do if my GCC Technologies P3-132S has a problem on the Y axis?
If your GCC Technologies Plotter displays a message indicating an obstruction to the carriage relating to a problem on the Y axis, correct the problem and re-power on to reboot system.
What to do if GCC Technologies P3-132S blade sensor malfunctions?
If your GCC Technologies Plotter displays a message indicating a blade up/down sensor malfunction, re-power on to reboot the system. If the problem persists, find a serviceman.
Safety precautions and recommendations before installing the cutting plotter.
Detailed instructions on how to install and adjust the cutting blade.
Instructions for connecting the cutting plotter via USB or Serial port.
Instructions for loading sheet and roll media into the plotter.
Procedure for adjusting cutting force and offset values for optimal results.
Details on AAS operation and requirements for registration marks.
Troubleshooting steps for when the cutting plotter does not operate.
Solutions for common error messages and operational failures.
Guidance on resolving issues related to software compatibility and drivers.
General| Brand | GCC Technologies |
|---|---|
| Model | P3-132S |
| Category | Plotter |
| Language | English |
To Next Page