ERROR CODES
K0553 Revision D 153 [EN] English
310 Reserved
311 Cannot connect Hand Term while safe at ground for this version of ADTS505
312 RtCAS is fixed and cannot be altered
313 Calibration date not entered. Enter the calibration date
314 No Handset code in LDK flash
315 Invalid Pt/Pt rate aim entry whilst in aero units
316 Invalid Qc/Qc rate aim entry whilst in Pt ramp mode
317 Invalid Pt/Pt rate aim entry whilst in Qc ramp mode
318 Entry capped to ground pressure specification limit
319 Controller board in position 1 programmed as controller 2
320 Controller board in position 2 programmed as controller 1
321 Board temperature error
322 Source sensor pressure initialisation error
323 Source sensor vacuum initialisation error
324 Board temperature read error
325 Source sensor pressure read error
326 Source sensor vacuum read error
327 ADC synchronisation initialisation error
328 ADC apply valve acquisition error
329 ADC release valve acquisition error
330 ERROR_DRIVER_IO_MAIN_ADC_ACQ_TMR_APP
331 ERROR_DRIVER_IO_MAIN_ADC_ACQ_TMR_REL
332 Pump PWM hardware fault
333 PT control sensor checksum error
334 PT control sensor diode ADC acquisition error
335 PT control sensor frequency acquisition error
Error Number Description