POWER-UP ROUTINE
[EN] English 37 K0553 Revision D
9) If the serial number of the ADTS for connection is not in the list, then close the list by
touching the "cross" icon. Select New scan for devices. Wait while a search for active
devices is performed.
10) Select the required serial number device from the list and touch the "tick" icon. Wait while
connection is established.
If the pairing has been successful the "Bluetooth® antenna icon" icon is now displayed in the
status indicator area of the ADTS Touch, and the Bluetooth LED will be SOLID, see also ADTS
Touch.
Bluetooth is available in both ON and Standby modes on ADTS553/554 due to the dual handter-
minal support requirement.
Wireless operation of the ADTS is now available. See also, section Bluetooth®.
To Next Page
Loading...
