Software Configuration CNF 008 RAID System Recovery and Configuration
Page 143
n CNF 008 RAID System Recovery and Configuration
Section 1: Introduction
This job card outlines how recover the RAID system and restore it to its original, factory-shipped
configuration. Performing his procedure should normally be necessary only if the RAID system has
been corrupted or a component has failed because the factory-built unit comes preloaded with the
necessary software.
Section 2: Prerequisites
u
Windows 2000 Server registration ID number.
u
Video cable is properly connected between the computer and the monitor.
u
Centricity RA600 Workgroup Server Recovery CD-ROM set is available
u
Centricity RA600 license file diskette is available
Section 3: Procedure
3-1 Restoring Original System Configuration
Caution
!
All data and programs on the system disk will be erased.
To Next Page
Loading...