Hardware Installation IST 011 Installing Global Modem
Page 86
n IST 011 Installing Global Modem
Section 1: Introduction
This job card describes how to install the GE global modem.
Section 2: Material Required
GE Global Modem Kit, including
u
DB24M-to-DB9F serial cable and
u
Modem kit (Includes modem, universal power supply, phone cables, customer property label,
phone company adapter kit, adhesive foot pads, and Velcro mounting tape strips).
Section 3: Prerequisites
Different countries have different requirements for how modems must function. Therefore, before
you use the modem in a given country,
u
you must first verify that it is approved for use in that country and
u
you must configure the modem to match the defaults of the country in which you will use it.
To find these conditions, go to the modem supplier’s GEMS support web site at www.MultiTech.com/
support/gems/
Note: The Global Modem driver is factory loaded and configured to operate through the COM1 port.
Section 4: Procedure
To Next Page
Loading...