GE CS5500 User Manual

Message Definition Action
Expansion
Over-Current
The expansion module has detected an
excessive amount of current being drawn
from one of its outputs and has disabled
the output as a means of protection.
Check the module for wiring faults.
Expansion
Power Trouble
The mains power supply is not connected
to an expansion module power supply.
Reconnect the mains power supply and
ensure it is working properly.
Expansion
Siren Trouble
The connection to an expansion module’s
siren is broken.
Repair the open circuit.
Expansion
Trouble
An expansion module or keypad is not
reporting to the control panel.
Ensure that the module is connected
properly to the control panel.
Zone Problem,
Press OK
There is a problem with a zone or zones.
Press OK to identify the zone(s) and the
problem condition.
One of the following messages is
displayed when you press
OK
.
CleanMe
A specific smoke detector
(for example, DP721) is
dirty. The panel detects a
degree of pollution in the
chamber of the fire/smoke
detectors.
Clean the detection chamber of the smoke
detector.
Lost
The system has not
received RF sensor
transmissions for a long
period of time. Depending
on how the system is
programmed, this
condition activates a
service report. In addition,
it may activate a tamper
alarm if armed.
Ensure that the wireless zone module is
receiving power and has not been tampered
with. Repair any faults.
Low Battery
An RF sensor battery is
low.
Replace the battery.
Short Loss The system has not
received RF sensor
transmissions for a short
period of time. This
condition prevents arming.
Ensure that the wireless zone module is
receiving power and has not been tampered
with. Repair any faults.
Tamper
There is a problem with
the wiring.
Check the zone and zone sensors for
damage and repair any faults.
Trouble There is a problem with
the wiring.
Check the zone and zone sensors for
damage and repair any faults.
Table 20 Service messages

GE CS5500 Specifications

General

Brand	GE
Model	CS5500
Category	Keypad
Language	English