Term Definition
Zone Inactivity Monitor
A zone characteristic that sends a report to the central station when the zone does
not change conditions within a specified time period. (Zone Types)
A menu option that sends a report to the selected phone number when a zone
inactivity event occurs. (Phone Numbers)
A menu option that sets the zone inactivity time. It is possible to specify this time in
minutes or hours. (Timers)
A menu option that sends a report to the central station when a zone inactivity
event occurs, depending on the condition of the panel dialler. (CS7001 GSM
Module)
See also Panel Dialler OK Events and Panel Dialler Not OK Events
Zone Lost Gives Tamper
A menu option that sends a report to the central station when a wireless zone
sensor is lost and activates a tamper alarm. Different reports are sent depending
on the system status. When armed the tamper and the lost report are sent. When
disarmed only the lost report is sent.
Zone Name
A menu option that allows the installer to define names for each installed zone.
For example, Zone 1 can be named Living Room PIR. (Zones)
A menu option that enables the home automation system to change zone names
on the control panel. (Commands/Requests)
Zone Names
See Zone Name
Zone Restore
A menu option that sends a report to the central station when zones are restored.
Zone Snapshot
A menu option that allows the control panel to send a snapshot of the current
status of the zones. A snapshot sends the tripped, bypassed, trouble/tamper and
alarm memory state for sixteen zones. This is done on a zone-by-zone basis.
(Transition Broadcasts)
A menu option that enables the control panel to respond to zone snapshot
requests sent by the home automation system. (Commands/Requests)
Zone Status A menu option that sends the entire status for one zone. (Transition Broadcasts)
A menu option that enables the control panel to respond to zone status requests
sent by the home automation system. (Commands/Requests)
Zone Tamper
A menu option that sends a report to the central station when a zone tamper
occurs. (Communications>Reporting)
A menu entry that groups report codes that are sent to the central station when a
zone tamper event occurs. (Report Codes)
Zone Trouble
A menu option that sends a report to the central station when a zone trouble
condition occurs. (Communications>Reporting)
A menu entry that groups report codes that are sent to the central station when a
zone trouble condition occurs. (Report Codes)
Zone Trouble and
Restores
A menu option that sends a report to the selected phone number when a zone
trouble condition occurs. A report is also sent when the trouble condition is no
longer active. (Phone Numbers)
A menu option that sends zone trouble and restore reports to the central station,
depending on the condition of the panel dialler. (CS7001 GSM Module)
See also Panel Dialler OK Events and Panel Dialler Not OK Events
Zone Type
A menu option that specifies the zone type of a particular zone. There are 20
different zone types. The default zone types can be customised.
Zone Type Name
See Zone Type Name
Zone Type Names
A menu option that allows the installer to define names for each installed zone
type. For example, Type 1 can be named Burglary A Alarm, Type 2 can be named
Fire Alarm, Type 3 can be named Entry/Exit and so on.
Zone Types
A menu entry that groups zone type characteristics and allows the installer to
select a pre-defined zone type. There are 20 pre-defined zone types. The
characteristics of each zone can be changed. For example, if a keypad beeps, if
the zone is a delay 1 or delay 2 zone, a 24-hour zone and so on. (Inputs)
A menu entry that groups all reporting codes for the selected zone type. (Report
Codes)
To Next Page
Loading...
Need help?
General