GE DewPro MMY30 - Chapter 4: the Optional Display;User Interface (Option G); Dewpro with Display Assembly; Replacing the Display; The Optional Display;User Interface (Option G)

The Optional Display/User Interface (Option G) 4-1
November 2005
Installation If the DewPro is equipped with an optional display/user interface,
follow the procedure below to access the buttons.
Figure 4-1: DewPro with Display
DewPro with Display
Assembly
1. Unscrew and remove the protective lid from the top of the DewPro
(as shown in Figure 4-1 above), exposing the display module
below. The buttons V, H, + and - are now accessible.
Replacing the Display 2. The display unit snaps onto the printed circuit board, resting on
four posts. When removing the display, push one post to the
outside, using a small screwdriver, and pull the display out.
3. Then unplug the display cable.