GE GTD72EBSN0WS Installation Instructions

17
Installation Instructions
REVERSING THE DOOR
ABOUT REVERSING THE DOOR
IMPORTANT NOTES:
• Read the instructions all the way through
before starting.
• Handle parts carefully to avoid scratching
paint.
• Set screws down by their related parts to avoid
using them in the wrong places.
• Provide a non-scratch work surface for the
door.
• Normal completion time to reverse the door
swing is 30–60 minutes.
IMPORTANT:
Once you begin, do not move the cabinet
until door swing reversal is completed. These
instructions are for changing the hinges from
the right side to the left side - if you ever want to
switch them back to the right side, follow these
same instructions and reverse all references to the
left and right.
Tools needed:
n Quadrex #1 bit screwdriver otherwise standard #2
Phillips screwdriver
n Tape-tipped putty knife
n Small flat blade screwdriver
Before you start
Unplug the dryer from its
electrical outlet
Choose the REVERSING THE DOOR
instructions
A
or
B
for your model.
A
REVERSING THE DOOR - SOLID DOOR
MODELS
1
Open the door approximately 130 degrees. With a
putty knife, remove the 4 plastic caps located
along the left side of the front panel and set them
aside.
2
Remove the bottom screw from each hinge (right
side) and partially insert them into each top hinge
hole on the left side.
NOTE: All 4 front panel hinge screws will now be
in the top hinge holes - 2 on the left and 2 on the
right.
3
Loosen each top hinge screw on right side.
Remove the door and place it on a protective flat
surface to avoid any damage.
4
Remove both the blind plate and the strike plate
and install them in opposite positions.
A
REVERSING THE DOOR - SOLID
DOOR MODELS (cont.)
Plastic Cap (4)
Left side of
front panel
Blind
plate
Strike
plate
Loosen each
top hinge screw
on right side

GE GTD72EBSN0WS Specifications

General

Brand	GE
Model	GTD72EBSN0WS
Category	Dryer
Language	English