GE GTD72EBSN0WS Installation Instructions

20
Installation Instructions
REVERSING THE DOOR (cont.)
B
REVERSING THE DOOR - GLASS
PANEL DOOR MODELS (cont.)
8
Mount the assembled door on the 2 upper left side
hinge screws installed in step 2. Move the hinge
screws loosened in step 2 into the lower left side
screw holes and firmly tighten all 4 screws.
9
Install the 4 plastic caps removed in step 1 into the
4 right side front panel holes.
NOTE: To return the door to the original setup, follow
these instructions, swapping “left” and “right”.
When you finish
Plug the dryer back into
its electrical outlet.
Door
Hang door and
tighten screws
B
REVERSING THE DOOR - GLASS
PANEL DOOR MODELS (cont.)
6
Remove and swap the 2 plastic caps and the 2
hinges.
7
Rotate the outer door 180 degrees, mount the
inner door back into the outer door frame and
secure with the screws removed in step 5. Make
sure you mount the hinges on the side opposite
the pocket.
Install hinges from
oposite side
here
Install plastic caps
from oposite side
here
Plastic
caps
Hinges
Inner door
Inner door
Outer door
Rotate outer
door 180°
Inside
screw
Inside
screws
Pocket screws
Inside
screw
Door
hinge
screws
Inside screw
Inside
screw
Plastic Cap (4)
Right side of
front panel

GE GTD72EBSN0WS Specifications

General

Brand	GE
Model	GTD72EBSN0WS
Category	Dryer
Language	English