Installation Instructions
Operating Instructions
Troubleshooting Tips
Consumer Support
Safety Instructions
www.GEAppliances.ca
3
PROPER INSTALLATION
7KLVGU\HUPXVWEHSURSHUO\LQVWDOOHGDQGORFDWHGLQDFFRUGDQFHZLWKWKH,QVWDOODWLRQ,QVWUXFWLRQVEHIRUH
it is used, present in this manual.
Properly ground dryer to conform to all governing
codes and ordinances. Follow details in
Installation Instructions section.
Install or store where it will not Ee e[posed to
temperatures Eelow free]ing or e[posed to the
weather.
&onnect to a properly rated, protected and si]ed
power supply circuit to avoid electrical overload.
5emove the protective ¿lm from Eoth the control
panel and the door.
Remove all sharp packing items and dispose of all
shipping materials properly.
'o not remove the vent protector from the Eack
of the dryer. Pull the protector out and down to its
lowest position and connect the exhaust duct to
the dryer. The lowered protector will prevent the
duct from getting crushed.
Dryers MUST Ee exhausted to the outside to
prevent large amounts of moisture and lint from
Eeing Elown into the room.
8se only rigid metal or ÀexiEle metal 1 cm 4µ
diameter ductwork inside for exhausting to the
outside.
USE OF PLASTIC OR OTHER COMBUSTIBLE
DUCTWORK CAN CAUSE A FIRE. PUNCTURED
DUCTWORK CAN CAUSE A FIRE IF IT COLLAPSES
OR BECOMES OTHERWISE RESTRICTED IN USE
OR DURING INSTALLATION.
1
2
For complete details, follow the Installation
Instructions.
Exhaust/Ducting:
To Next Page
Loading...
Need help?
General
