GE JBP78

Adjustthe oven thermostatmDo it yourself!
Youmay find that your new oven cooks differently than the one it replaced.
Useyour new oven for a few weeks to become more familiar with it. If you
still think your new oven is too hot or too cold, you can adjust the thermostat
yourself.
Donotuseinexpensivethermometers,suchasthosefoundingrocerystores,tocheckthetemperature
settingofyouroven,Thesethermometersmayvary20-40degrees,
NOTE:Thisadjustmentwill notaffectthebroilingorthese!f-deadngtemperatures.
Theadjustmentwill beretainedinmemoryafterapower_ilure,
ForModels with Onlyan Oven TemperatureKnob
OVENON 0_r P.E.EATED ] Put the knob in tim OFFposition.
_7/qlF'x %rz® _Pull the knob off by pulling straight oul.
{ AUTO ,Y / I I \ _ " ' ' '
,_=1o.... (/( II ) b_ "
CLEAN _ )
J ,-essandho dtheHOrrERo,-COOtERb=,,on
550 350 ( o
sso_o" _o ...................................for 5 seconds to make the oven 20 F. hotter or
¢0o2 F. cooler.
sso)'l- r _-_ 3S0
[ .,,, J
tappearancemayvary)
iigReplace tim knob.
When you are adjusting file lherlnoslal, lhe tbllo_dng
lights _11 flash indicating where tile flmnnoslal _dll be
sel when you release lhe adjuslmenl bullon:
OVEN ON."Indicates the thermostat will be set at the factory
setting,
PREHEATED."Indicatesthe thermostat will be set 20°F,hotter,
, LATCH DOOR."Indicates the thermostat will be set 20°F,cooler,
For Models with Padsand an Oven Temperature Knob
HOUR
_I'ut the ()yen Temperature knob in the OFFposition.
_l'ress and hold lhe HOUR+/- pads for 5 seconds
_until lhe display changes.
J lk'tbre display changes back, press lhe HOUR+/-
a pads lo increase or decrease lhe lemperalure in
5 degree increments.
oKo
Tile oven temperalure can be increased up lo ,)a F.
oKo
holler or can be decreased doom 1o ,)a F. coole_.
If the oven ar!justment is set cooler than tile thctoD7
setting a minus sign (-) and the ottsel temperature will
appear in the display.
_Wait severalsecondsfor tile control to aulomatically
sel and relm-n to its previous setting. 23 ..............................................