_jj Power Cord Strain Relief Installation
Remove the lower rear range _d_ing (over to expose the connector block
"_and 1)racket.
Remove the knockoul ring (1Y,_")localed on bracket directly below the
{u_ conneclor. To remove lhe knockoul, use a pair of pliers 1obend lhe
knockoul dng away flom ll_e bracket and lwisl until dng is removed.
Knockoutring inbracket. Knockoutring removed.
1_ Assemble the su-ain relief in the hole. Insert lhe power cord lhrough lhe
]_;* suain relief and lighten. Allow enough slack 1oeasily attach the cord
lenninals to the connector block. If labs m-epresent al lhe end of lhe _dnged
strain relief, they can be removed*6r better fit.
NOTE:DonotinstallthepowercordwithoutaStrainrelief
....--
(shownremoved) ' -_ _i k
Strainrelief/ ! '"_.-_r cord (Sptrioiindreli_:itb,rl_Cakngtecord.Notpa,tofrange.)
35
To Next Page
Loading...
