4-Wire ConduitInstallation
Remove rite 3 screws from rite connector block. Remove rite grounding suap
fiom lhe connecu_r block middle locadon and rite screw connecting it k_ the
fimne of the range. Insert bare xdres belween rite conneclor block terminals
and movable nuls. Tighmn screws securely. Auach ground x,_re u) the fiame of
the range.
WARNING:Connector block is approved for copper wire connection
only. If aluminum wire is used,see note below.
NOTE: ALUMINUM WIRING
Do not connect aluminum _dre lo connector block.
Use copper building xdre rated fi)r lhe correct amperage and vohage lo
make 3 (three) 3" copper.jumper _dres. Connect _dre as per Step 6 or 7
depending on number of_dres.
[_ Splice copper xdres lo aluminum x_dng using special connector terminals
.........' desig]md and 1_L-approved for.joining copper t_)aluminum and follow the
conneclor manuiacmrer's recommended procedure closely.
Wireused,locationandenclosureofspfices,etc.,mustconformto goodwiringpractices
andlocalcodes.
39
To Next Page
Loading...
