QUESTIONS?
USE THIS PROBLEM SOLVER
PROBLEM
“F-AND A NUMBER”
FLASH
IN THE DISPLAY
“OFF” APPEARS
IN
THE DISPLAY
CLOCK AND
TE$’IER
IX)
NOT
WORK
OVEN
WILL
NOT WORK
OVEN LIGHT
DOES
NOT WORK
SURFACE LIGHT
DOES NOT WORK
FOOD
DOES NOT
BROIL PROPERLY
FOOD DOES
NOT
ROAST
OR BAKE
PROPERLY
OVEN TEMPERATURE
TOO HOT
OR TOO COLD
OVEN WILL NOT
SELF-CLEAN
POSSIBLE CAUSE
●
If
the
time display flashes “F-and a number”, you have function error
code,
Press the
CLEAR/OFF pad. Allow the oven to cool for one hour. If the failure
code repeats, disconnect all power to the range. Call fur service.
*
Oven
is
too hot for
the self-clean cycle to be set.
*
Bake
or
Broil
cycles attempted too soon
after
self-cleaning.
Let the
oven
cool longer.
●
Make sure the
electrical plug is
plugged
into a live, properly grounded
power
outlet.
*
Check
for power outage.
●
See the
(lven
Control$
Clock
and Timer section of this guide.
●
The plug on the
range
is
not
completely
inserted in the electrical outlet.
* The circuit breaker in your house has been tripped, or a fuse has been blown.
● The oven controls are not properly set.
● The door left
in
the locked position after cleaning.
● The
light
bulb is
loose
or defective. Tighten or replace.
. The switch operating the oven light is broken. Call for service.
*
The fluorescent
liglht
is loose or defective. Adjust
or
rep~ace.
●
Press
the
switch for 2 seconds.
lf
the light does not come on, repeat.
●
The switch operating the light is broken.
Call
for
service.
● The oven is not set at BROIL.
● The door was not left open to the broil stop position as recommended.
● Improper shelf position being used. See the Broiling Guide.
● Food is being cooked on hot pan.
s
Cookware is not suited for broiling.
● Aluminum foil used on the broil pan rack has not been fitted properly
and slit as recommended.
● The oven is not set at BAKE.
● Shelf position is incorrect. See the Roasting or Baking sections.
● The oven shelf is not level.
● Incorrect cookware or cookware of improper size is being used.
● The oven thermostat needs adjustment. See the Adjust the Oven Thermostat–
Do It
Yourself section.
● The oven thermostat needs adjustment. See the Adjust the Oven
Thermostat—
Do It
Yourse~sectiort.
● The oven temperature is too high to set self-clean operation. Allow the range to
cool to room temperature and reset the controls.
● The door latch handle not moved all the way to the right.
● Probe is plugged
in
the oven. Remove the probe.
52
To Next Page
Loading...
