GEAppliances.com
How to Delay the Start of Cleaning
Make sure tim clock shows tim correct
time of day.
[] Touch the SELFCLEANpad.
[] Using the INCREASEor DECREASE
pads, enter the desired clean time.
[] 'lbuch the STARTTIMEpad. _12qe
earliest start time you can set will
appear in the display:
[] Using the INCREASEor DECREASE
pads, enter the time of day you want
the clean cycle to start.
[] Touch the START pad.
_12qedoor locks automatically: _12qe
display" will show the start time. It will
not be possible to open tim oven door
until the mmperamre drops below the
lock temperature and the LOCKEDdoor
light goes off
When the LOCKEDdoor light is off, open
tim door.
After a Clean Cycle
You may notice some white ash in the
oven. Wipe it up with a damp cloth after
the oven cools.
tfwhitespotsremain,removethemwithasoap-
filledsteelwoolpadandrinsethoroughlywith
a vinegarandwatermixture.
_12qesedeposits are usually a salt
residue that cmmot Ix- removed by
the clean cycle.
If the oven is not clean after one clean
cycle, repeat the cycle.
Apply a small amount of vegetable oil to
a paper towel and wipe the edges of the
oven shelves with the paper towel. Do not
spray with Pare ®or oflmr lubricant sprays.
/;_5You cannot set the oven J[br cooking
until the oven is cool enough J[br the
door to Ix- unlatched.
N While the oven is self-cleaning, you
can press the CLOCKpad to display
the time of day: To return to the
clean countdown, press tim COOKING
TIMEp d.
21
To Next Page
Loading...
