Cleaning the glass cooktop, somemode/sl GEAppliances.com
t
I
Clean your cooktop after
each spill. Use CERAMA
BRYTE®Ceramic Cooktop
Cleaner.
Normal Daily Use Cleaning
ONLYuse CERAMABRYTE®CeramicCooktop
Cleaneron the glass cooktop. Other creams
may not be as effective.
Tomaintain and protect the surface of your
glass cooktop, follow these steps:
r-_ Before using the cooktop for the first time,
clean it with CERAMABRYTE®Ceramic
Cooktop Cleaner.Thishelps protect the
top and makes cleanup easier.
[] Daily useof CERAMABRYTE®Ceramic
Cooktop Cleanerwill help keep the
cooktop looking new.
r_ Shakethe cleaning cream well. Apply a
few drops of CERAMABRY1-E®Ceramic
Cooktop Cleanerdirectlyto the cooktop.
r_ use a paper towel or CERAMABRYTE®
Cleaning Padfor Ceramic Cooktopsto
clean the entire cooktop surface.
[] Use a dry cloth or paper towel to
remove all cleaning residue. No need to
rinse.
NOTE:It is very important that you DO NOT
heat the cooktop until it has been cleaned
thoroughly.
Burned-On Residue
Use a CERAIVlABRYTE®Cleaning Pad
for Ceramic Cooktops.
WARNING: DAMAGEtoyour D
glass surface may occur if you use scrub pads
other than those recommended, r_
i-f] Allow the cooktop to cool.
Spread a few drops of CERAIVlABRYTE®
CeramicCooktop Cleaneron the entire
burned residue area.
@
Using the included CERAMABRYTE®
Cleaning Padfor Ceramic Cooktops, rub
the residue area, applying pressure as
needed.
If any residue remains, repeat
the steps listed above as needed.
For additional protection, after all
residue has been removed, polish the
entire surface with CERAMABRYTE®
CeramicCooktop Cleanerand a paper
towel.
The CERAMABRVTE®Ceramic
Cooktop Scraper and all
recommended supplies are
available through our Parts
Center. See instructions under "To
Order Parts" section on next page.
NOTE:Do not use a dull or nicked
blade.
Heavy, Burned-On Residue
%
Allow the cooktop to cool.
Use a single-edge razor blade scraper
at approximately a 45° angle against
the glass surface and scrape the soil. It
will be necessary to apply pressure to
the razor scraper in order to remove the
residue.
@
After scraping with the razor scraper,
spread a few drops of CERAIVlABRYTE®
CeramicCooktop Cleaneron the entire
burned residue area. Use the CERAIVlA
BRYTE®Cleaning Pad to remove any
remaining residue.
[]
For additional protection, after all
residue has been removed, polish the
entire surface with CERAMABRYTE®
CeramicCooktop Cleanerand a paper
towel.
29
To Next Page
Loading...
