www.geappliances.ca
Safety Instructions
Operating Instructions Care and Cleaning
Troubleshooting Tips
Consumer Support
Oven Light Bulbs
NOTE: The glass cover should be
removed only when cold. Wearing latex
gloves may offer a better grip.
CAUTION: Before replacing your
oven light bulb, disconnect the electrical
power to the oven at the main fuse or
circuit breaker panel.
Be sure to let the light cover and bulb
cool completely.
For your safety, do not touch a hot bulb
with bare hands or a damp cloth.
To remove:
Turn the glass cover
counterclockwise 1/4 turn until
the tabs of the glass cover clear
the grooves of the socket.
Using gloves or a dry cloth, remove
the bulb by pulling it straight out.
To replace:
Use a new 130-volt halogen bulb,
not to exceed 50 watts.
Using gloves or a dry cloth, remove
the bulb from its packaging. Do not
touch the bulb with bare fingers.
Push the bulb straight into the
receptacle all the way.
Place the tabs of the glass cover into
the grooves of the socket. Turn the
glass cover clockwise 1/4 turn.
For improved lighting inside
the oven, clean the glass cover
frequently using a wet cloth. This
should be done when the oven is
completely cool.
Reconnect electrical power to
the oven.
Bulb
Socket
Tab
Glass cover
Use gloves
or cloth
Receptacle
Receptacle
31
Press down and pull out.
Removable Oven Floor
To remove the oven floor:
Remove the oven door using the
instructions in the Lift-Off Oven Door
section.
Press down and pull out the
removable oven floor.
Clean the oven floor with warm
soapy water.
When reinstalling the oven floor, be
sure to slide it all the way to the back
of the oven.
IMPORTANT: Always replace the
removable floor before the next use.
All oven racks may be cleaned by hand
with an abrasive cleaner or steel wool.
After cleaning, rinse the racks with clean
water and dry with a clean cloth. Gray
porcelain-coated oven racks may remain
in the oven during the self-cleaning
cycle without being damaged. The shiny,
silver-colored oven racks may remain
in the oven during the self-cleaning
cycle, but they will lose their luster and
become hard to slide.
It will be necessary to grease all oven
rack side edges with a light coating of
vegetable oil after cleaning them by hand
or in the oven. This will help maintain
the ease of sliding the racks in and out of
the oven.
Oven Racks
Oven rack
To Next Page
Loading...
Need help?
General
