3–20 LM10 MOTOR PROTECTION SYSTEM – INSTRUCTION MANUAL
PDU OPERATIONS CHAPTER 3: INTERFACE
power factor, kW, average current, and current unbalance. Pressing the History button
again advances to the next history record.
• Status: Pressing the Status button displays the current conditions of the LM10. The
following items are displayed: phase currents, ground current, voltage, kW, power
factor, average current, current unbalance, and elapsed motor hours.
• Config.:In User mode (default startup condition, no passcode entered), pressing the
Config. button displays the following programmed parameters: English or Spanish
display, CTs and CPTs, starter type, Run 1 setup, Run 2 setup, time delays, other
settings, auxiliary relay faults, and passcode/login.
In Configuration mode (after proper passcode entered), the same Config screens are
available to edit. In addition, the following restricted-access options are displayed: run
operations and restore factory default configuration.
• Reset: At the main startup screen, the Reset button clears fault conditions, thereby
allowing the motor to be ready to restart. At all other screens, pressing the Reset
button brings the previous menu.
To Next Page
Loading...
