3–24 LM10 MOTOR PROTECTION SYSTEM – INSTRUCTION MANUAL
ENERVISTA LM10 SOFTWARE CHAPTER 3: INTERFACE
• Download: Sends the configuration parameters from memory to the connected LM10.
Note that you must be logged into the LM10 as a configurator to download
configuration parameters.
• Upload: Gets the configuration parameters from the connected LM10 and saves them
in memory.
• Port: Shows the available communications ports. The current selected COM port is
indicated by a check mark. The green power LED indicates that communication is
currently established with the LM10.
The Help menu has following submenu items:
• Manual: Opens the enerVista LM10 setup software help file.
• About: Displays the enerVista LM10 setup software version and information.
The EnerVista LM10 software uses hot keys for the following that equate to a mouse click
on the PDU keys.
Table 3–1: EnerVista Hot Keys
Keys on PDU Hot Keys
Reset Esc, R, r
Status S, s
History H, h
Config C, c
Up arrow 'Up arrow' key
Down arrow 'Down arrow'
Enter 'Enter' key
To Next Page
Loading...
