GE LOGIQ e R4 Series - CHAPTER 8 Replacement Procedures; Overview of Replacement Procedures Chapter; Disassembly and Re-assembly Procedures

GE
Direction 5370626-100, Revision 18 LOGIQ e/LOGIQ e Vet/LOGIQ i/Vivid e Basic Service Manual
Chapter 8 Replacement Procedures 8-1
Chapter 8
Replacement Procedures
Section 8-1
Overview
8-1-1 Purpose of Chapter 8
This chapter describes replacement procedures for the following modules and subsystems.
Section 8-2
Disassembly/Re-assembly of LOGIQ e/LOGIQ e Vet/LOGIQ i/Vivid e
8-2-1 Warning and Caution
Table 8-1 Contents in Chapter 8
Section Description Page Number
8-1
Overview
page 8-1
8-2
Disassembly/Re-assembly of LOGIQ e/LOGIQ e Vet/LOGIQ
i/Vivid e
page 8-1
8-2-1
Warning and Caution
page 8-1
8-2-2
Handle Assy (FRU No. 313)
page 8-2
8-3
Loading the System Software
page 8-4
8-4
Checks after FRU replacement (Debrief Guidelines)
page 8-23
WARNINGWARNING
ONLY QUALIFIED SERVICE PERSONNEL SHOULD REMOVE ANY COVERS OR
PANELS. ELECTRICAL HAZARDS EXISTS AT SEVERAL POINTS INSIDE. BECOME
THOROUGHLY FAMILIAR WITH ALL HAZARDOUS VOLTAGES AND HIGH CURRENT
LEVELS TO AVOID ACCIDENTAL CONTACT
CAUTION
Do not wear the ESD wrist strap when you work on live circuits and more than 30V peak is
present.