GE LOGIQ e R4 Series - Software Version Check out; Functional Check-Out

GE
Direction 5370626-100, Revision 18 LOGIQ e/LOGIQ e Vet/LOGIQ i/Vivid e Basic Service Manual
Chapter 3 System Setup 3-33
Section 3-10Software Version check out
3-10-1 Functional Check-out
1.) Power on LOGIQ e/LOGIQ e Vet/LOGIQ i/Vivid e scanner and wait until system booting to main
screen.
2.) Press Utility/Config
key on control panel.
3.) Choose the About
button on the right.
4.) Check whether "Software version" is the right version for use.
Figure 3-29 About
Figure 3-30 Software version