GE LOGIQ E10 Series

LOGIQ™ E10 Series
Power Assistant and Scan on Battery Guide
www.gehealthcare.com
The battery protects system data for a limited amount of time
in the event of inadvertent AC power loss.
Options:
Power Assistant- system power is maintained by the battery
when AC power is lost or the power cord is unplugged.
Reduces the start up time for portable exams. The system will
run up to 20 minutes after AC power is disconnected.
Scan on Battery (Option on LOGIQ E10s only)- allows the
user to scan using battery power (AC unplugged). With a fresh
battery that is fully charged, the LOGIQ E10s stays powered
for approximately 50 minutes.
Note: Detailed battery function and service information is outlined
in the Basic User Manual.

GE LOGIQ E10 Series Specifications

General

Model	LOGIQ E10 Series
XDclear Technology	Yes
Electronic 4D	Yes
Power Requirements	100-240 V AC, 50/60 Hz
Category	Ultrasound Imaging System
Touch Panel	12.1-inch touch panel
Storage	Integrated hard drive
Connectivity	DICOM, USB, Ethernet
Application	Abdominal, Vascular, Cardiac, Musculoskeletal, Small Parts, OB/GYN
eM6C probe	Available
Transducer Connectors	4 active transducer ports
Probe Frequency Range	1-20 MHz
Architecture	cSound™ Architecture

Summary

Power Assistant Operation Guide

Entering and Using Power Assistant

Procedure to enter PA mode, actions to complete before, and actions not to perform in PA.

Power Assistant Battery Status

Viewing current battery status, understanding battery status icons, and charging information.

Scan on Battery Operation Guide

Starting and Using Scan on Battery

How to start scanning on battery, system messages, and warnings.

Scan on Battery Status and Charging

Battery status icons, charging process, and approximate charging time.

Battery Maintenance and Health

Refreshing the Battery

Recommended procedure to maintain battery life and accuracy every six months.

Battery Deterioration Handling

Identification of battery deterioration messages and necessary actions.