64 | GE Oil & Gas ® 2014 General Electric Company. All rights reserved.
APPENDIX B
SCREEN DESCRIPTION FOR BASIC SETUP MENU – 2/2
ZERO
When displayed, empty the tank (or simulate) so that displacer is fully out of liquid. Wait
until the displacer is stable then press * to define the low reference (REF L).
SPAN
When displayed, fill the tank (or simulate) so that displacer is fully immersed in liquid. Wait
until the displacer is stable then press * to define the high reference (REF H).
SAVE
Validate by pressing the * to start the saving procedure of parameters previously entered
in the instrument memory.
CANCEL
Validate by pressing the * to cancel the parameters saving procedure.
CHANGE SPECIFIC
GRAVITY
Enter that function to set the Specific Gravity of Service in case it is different fro
Specific Gravity of Calibration.
SPECIFIC GRAVITY of
SERVICE
Validate by pressing the * to set the Specific Gravity of the liquid of service if it is different
from the Specific Gravity of Calibration. Settable value ranges from 0.001 to 10.
LOW SPECIFIC GRAVITY of
SERVICE
Used in case of an interface instrument. Validate by pressing the
Gravity of the lighter liquid used in service if it is different from LSG CAL. Settable values
range from 0.001 to the value of HSG SER.
HIGH SPECIFIC GRAVITY of
SERVICE
Used in case of an interface instrument. Validate by pressing the
Gravity of the heavier liquid in service if it is different from HSG CAL. Settable values range
from LSG SER to 10.0.
SAVE
Validate by pressing the * to start the saving procedure of configuration parameters
previously entered in the instrument memory.
CANCEL
Validate by pressing the * to cancel the parameters saving procedure.
↑ BACK
Return to previous menu.
To Next Page
Loading...
