GE Masoneilan 12420 - Engineering Unit Menu Description; Filtering Menu Description

® 2014 General Electric Company. All rights reserved. Masoneilan 12400 Series Transmitter/Controller Instruction Manual | 71
APPENDIX D
SCREEN DESCRIPTION FOR ENGINEERING UNIT MENU
↓ ENG:%
Validate by pressing the * to enter the sub-
menu related to the level variable setting in
engineering units.
UNIT:%
Validate by pressing the * to select the desired engineering unit (%, cm, m, inch…) used to
express the level variable. Generally, the engineering unit is in %.
##.###
DECIMALS
Validate by pressing the * to set the number of decimals after the dot.
LOWER REFERENCE VALUE
Validate by pressing the * to set the lower
level value expressed in industrial unit
corresponding to the Low Reference (REF L). Always set at 0 if unit is %. Value ranges from 0 to
value of UPPER REFERENCE VALUE.
UPPER REFERENCE VALUE
Validate by pressing the * to set the higher
level value expressed in industrial unit
corresponding to the High Reference (REF H). Always set at 100 if unit is %. Value ranges from
LOWER REFERENCE VALUE to 9999.9.
SAVE
Validate by pressing the * to start the saving procedure of parameters previously entered in
the instrument memory.
↑ BACK
Return to previous menu.
SCREEN DESCRIPTION FOR FILTERING MENU
FILTERING
Validate by pressing the * to check the Filtering data.
DAMPING
Validate by pressing the * to check the Damping data.
DAMPING ON
Indicates first order Filtering function is activated.
DAMPING OFF
Indicates first order Filtering function is not activated.
DAMPING:s
Indicates damping value adjusted in the Advanced Setup menu.
↑ BACK
Return to previous menu.
SMART FILTERING
Validate by pressing the * to check the Smart Filtering parameters.
SMART FILTERING ON
Indicates the Smart Filtering function is activated.
SMART FILTERING OFF
Indicates the Smart Filtering function is not activated.
WINDOW of
INTEGRATION : s
Indicates the Window of Integration value adjusted in the Advanced Setup menu.
DEAD ZONE of
INTEGRATION : %
Indicates the Dead Zone of Integration value adjusted in the Advanced Setup menu.
WINDOW of
VALIDATION
Indicates the Window of Validation value adjusted in the Advanced Setup menu.
↑ BACK
Return to previous menu.