– 17 –
Ticking sound of
spark igniter persists
after burner lights
Ticking sound
persists after burner
is turned OFF
Flame “Popping”
Improper flame sensing.
Be sure the knob is in
the OFF position.
Defective igniter switch.
Simmer ring not seated
properly to base.
• Check igniter wiring.
• Replace the igniter.
• Remove knob and check the bottom of knob for buildup
of soil. If ticking persists, replace igniter switches.
• Replace the igniter switch.
• Ensure the simmer ring is properly seated to base and
1-1/16 in. nut is fully seated and tight (1/4 turn after
contact).
Problem Possible Causes What to Do
To Next Page
Loading...
Need help?
General
