GE Multilin G650 - Page 83

4-8 G650 Generator Protection & Control System GEK-113285A
4.1 ENERVISTA 650 SETUP SOFTWARE INTERFACE 4 HUMAN INTERFACES. SETTINGS & ACTUAL VALUES
4
4.1.5.2 ON LINE MODE
Figure 4–4: ON LINE MODE FILE MANAGEMENT
NO
Run EnerVista 650 Setup
Connect to the relay
(
“Communication>Com
p
uter>O
N
”
)
Modify and send to the
relay protection Settings
and rela
y
confi
g
uration
Is it necessary to
program
additional logic?
Launch the Logic Configuration tool in EnerVista
650 Setu
p(
“Set
p
oint>Lo
g
ic Confi
g
uration”
)
Create new or modify the existing logic
(
“File>O
p
en Pro
j
ect”
)
Compile (“Run>Compile”)
and save logic file (*.pep) and drawing design
(*.aut) in Logic Configuration tool (“File>Save
Project”)
Send logic to relay (“Run>Send Equations to
Rela
y
”
)
and Exit PLC Gra
p
hic Edito
r
Is the relay
completely
configured?
Save all settings & configuration (“File>Get info from relay”)
Store in the relay the Logic configuration files (*.pep, *.aut, *.lib) as well as the
*.650 for further logic changes. (“Communication>Upload info files to relay”)
NO
YES
YES