GE Multilin G650 - File Management

4-6 G650 Generator Protection & Control System GEK-113285A
4.1 ENERVISTA 650 SETUP SOFTWARE INTERFACE 4 HUMAN INTERFACES. SETTINGS & ACTUAL VALUES
4
4.1.5 FILE MANAGEMENT
File management with EnerVista 650 Setup software:
4.1.5.1 OFF LINE MODE
Figure 4–3: OFF-LINE MODE FILE MANAGEMENT
Run EnerVista 650 Setup
Open a *.650 file
(
“File>O
p
en” menu
)
Modify protection Settings
and rela
y
confi
g
uration
Is it necessary to
program
additional logic?
Launch the Logic Configuration tool in EnerVista
650 Setu
p(
“Set
p
oint>Lo
gi
c Confi
g
uration”
)
Create new or modify the existing logic:
(
“File>O
p
en Pro
j
ect”
)
Compile and save logic file (*.pep) and drawing
desi
g
n
(
*.aut
)
in Lo
g
ic Confi
g
uration tool
Exit PLC Graphic Editor and save the *.650 file
from the main a
pp
lication menu
Is the relay
completely
configured?
Save *.650 settings & configuration file
Store in the computer the Logic configuration files (*.pep, *.aut, *.lib) as
well as the *.650 for further logic changes.
YES
YES
NO NO