GE Multilin GEK-113000T User Manual

GE Multilin F650 Digital Bay Controller 5-3
5 SETPOINTS 5.2 PRODUCT SETUP
5
5.2PRODUCT SETUP 5.2.1 COMMUNICATION SETPOINTS
5.2.1.1 SERIAL PORTS
Baud rate and parity for COM1 and COM2 serial communication ports.
Table 5–2: SERIAL PORTS SETPOINTS
5.2.1.2 NETWORK (ETHERNET)
Ethernet communication parameters for COM3. Two different Ethernet addresses can be used, but the first IP has always
to be set as the second IP Address is an Alias. The ModBus Slave address used by Ethernet ports is the one set for COM2.
Table 5–3: NETWORK SETPOINTS
5.2.1.3 MODBUS PROTOCOL
ModBus Slave Addresses for serial and Ethernet communication and the ModBus port number used for ModBus TCP/IP.
For more detail information go to appendix B in this manual.
Table 5–4: MODBUS PROTOCOL SETPOINTS
PRODUCT SETUP > COMMUNICATION SETPOINTS >SERIAL PORTS
Name Default Value Step Range
COM1 Baud Rate 19200 [300 : 115200]
COM2 Baud Rate 19200 [300 : 115200]
Parity NONE [NONE:ODD:EVEN]
PRODUCT SETUP>COMMUNICATION SETPOINTS >NETWORK (ETHERNET) NETWORK
(ETHERNET)1 > NETWORK (ETHERNET)2
Name Default Value Step Range
IP Address Oct1 0 [0 : 255]
IP Address Oct2 0 [0 : 255]
IP Address Oct3 0 [0 : 255]
IP Address Oct4 0 [0 : 255]
Netmask Oct1 0 [0 : 255]
Netmask Oct2 0 [0 : 255]
Netmask Oct3 0 [0 : 255]
Netmask Oct4 0 [0 : 255]
Gateway IP Oct1 0 [0 : 255]
Gateway IP Oct2 0 [0 : 255]
Gateway IP Oct3 0 [0 : 255]
Gateway IP Oct4 0 [0 : 255]
PRODUCT SETUP>COMMUNICATION SETPOINTS >MODBUS PROTOCO
Name Default Value Step Range
ModBus Address COM1 254 [1 : 255]
ModBus Address COM2 254 [1 : 255]
ModBus Port Number 502 [0 : 65535]

GE Multilin GEK-113000T Specifications

General

Brand	GE
Model	Multilin GEK-113000T
Category	Controller
Language	English