GE Multilin GEK-113000T - Page 254

GEK-113000T F650 Digital Bay Controller C-29
APPENDIX C C.2 FACTORY DEFAULT CONFIGURATION
C
AR CONDS INPUT
SYNCHK CLOSE PERM NOT
NOT
LATCHED VIRT IP 15
BKR FAIL INITIATE Not Configured
GROUP 1 ACT ON Not Configured
GROUP 2 ACT ON Not Configured
GROUP 3 ACT ON Not Configured
FAULT REPORT TRIGG VO_083_GENERAL_TRIP
CLEAR FAULT REPORTS Not Configured
DEMAND TRIGGER INP Not Configured
DEMAND RESET INP OPERATION BIT 7
FREEZE ENERGY CNT Not Configured
UNFREEZE ENERGY
CNT
Not Configured
RESET ENERGY CNT OPERATION BIT 6
RESET KI2t COUNTERS OPERATION BIT 5
RESET BKR COUNTERS OPERATION BIT 5
SETPOINT>RELAY CONFIGURATION>OSCILLOGRAPHY
DIGITAL CHANNEL NAME SOURCE SIGNAL LOGIC SOURCE LOGIC
DIG_CHANNEL#1 TRIP VO_083_GENERAL_TRIP
DIG_CHANNEL#2 50/51P TRIP VO_019_PHASE_OVERCURRENT_TRIP
DIG_CHANNEL#3 50/51G TRIP
VO_069_GROUND_OVERCURRENT_T
RIP
DIG_CHANNEL#4 27 TRIP VO_073_27P_TRIP
DIG_CHANNEL#5 59 TRIP VO_074_59P_TRIP
DIG_CHANNEL#6 PICKUP VO_085_GENERAL_PKP
DIG_CHANNEL#7 50/51P PICKUP VO_007_PHASE_OVERCURRENT_PKP
DIG_CHANNEL#8 50/51G PICKUP
VO_009_GROUND_OVERCURRENT_P
KP
DIG_CHANNEL#9 27 PICKUP VO_045_27P_PKP
DIG_CHANNEL#10 59 PICKUP VO_046_59P_PKP
DIG_CHANNEL#11 79 READY AR READY
DIG_CHANNEL#12 79 IN-PROG AR RCL IN PROGRESS
DIG_CHANNEL#13 79 BLOCK AR BLOCK
DIG_CHANNEL#14 79 INHIBIT AR CONDS INPUT NOT
DIG_CHANNEL#15 79 LOCKOUT AR LOCKOUT
DIG_CHANNEL#16 Not Configured
OSCILLO TRIGGER OSCILLO TRIGGER
OPERATION BIT 8
VO_083_GENERAL_TRIP
SETPOINT>RELAY CONFIGURATION>OPERATIONS
OPERATION OPERATION TEXT SETTINGS VALUE/SOURCE
Operation1 CLOSE BREAKER
INTERLOCK(LOGIC) SYNCHK CLOSE PERM
FINAL STATES AND LOGIC BREAKER CLOSED
FRONT KEY I Key
INPUT Not configured
VIRTUAL OUTPUT Not configured
TIMEOUT 1000
CHANNELS ALL
SETPOINT>RELAY CONFIGURATION>PROTECTION ELEMENTS
PROTECTION ELEMENT SOURCE SIGNAL LOGIC SOURCE LOGIC