Remark :
In the menu “Select an option” 8 additional options can be selected. The
options 5 until 8 are not used for the moment and may therefore not be
selected. The options 1 and 4 are described below:
Option 1 : On the LCD screen “press * for help”. By this the status of the system and
the message “press * for help” are alternately displayed on the LCD screen.
This is only to inform the user of the user’s menu.
Option 2 : Light continuously on. By this the lights of the LCD display and the keys will
continue to light up, independently of the programming of the control panel.
(Adr 23, Segm. 2, option 1 = turn off the lights after one minute of inactivity).
Option 3 : ON if PIN should be hidden when programming user codes.
Option 4 : ON suppresses beeps when an RF transmission is lost.
Option 5 :
Reserved (Do not program).
Option 6 :
Option 7 :
Disable ARM and BYPASS led for Norway/Sweden (NX-148E v3.47)
Any zone Alarm has priority over the Pre-Alarm message “Type code to
disarm” on the LCD screen (NX-148E v3.49)
Option 8 :
Reserved (Do not program).
[*]-[9]-[4] SET KEYPAD NUMBER AND PARTITION
1. Enter [*]-[9]-[4] The LCD screen will prompt for a code.
2. Enter [program code] The LCD will now prompt you for the keypad number
followed by [*]. The current keypad number will be
displayed in the lower right hand corner.
3. Enter the keypad number
followed by [*]
The LCD will now prompt you for the partition number.
The current partition will be displayed in the lower
right hand corner.
4. Enter the partition number for
the keypad
The keypad will automatically exit this mode now.
NX-8-EUR Installation manual Page 20 02/07/06
To Next Page
Loading...
Need help?
General
