LOCATION 5 - PARTITIONS REPORTED TO PHONE N° 1 (1 segment, feature selection data)
Location 5 is used when the events to be reported to a phone number are based on the
partition, regardless of the event. If you use this location, you should program location 4 as “0”.
Segment 1
1 = Partition 1
2 = Partition 2
3 = Partition 3
4 = Partition 4
5 = Partition 5
6 = Partition 6
7 = Partition 7
8 = Partition 8
Telephone number 2
LOCATION 6 - PROGRAMMING PHONE N° 2 (20 segments, numerical data)
Phone N°2 is programmed in location 6. A “14” indicates the end of the phone number. Delays
of four seconds can be programmed at any point in the phone number by programming a
“13” in the appropriate segment. The system will always wait for a dial tone unless the first
digit of the phone number is a “13”; in this case, it will only delay. Tone (DTMF) dialling is
default. If you want pulse tone dialling, program a “15” in the segment where pulse dialling
should begin. If the entire number should be pulse dialling, program a “15” in the first segment.
Program an “11” for a “*”, and a “12” for a “#”.
Note: a zero is programmed as a “0”.
LOCATION 7 - ACCOUNT CODE FOR PHONE N° 2 (6 segments of numerical data)
Use location 7 to program the account code that is sent when phone N°2 is dialled. A zero in
the account code is programmed as a “0”. A “10” indicates the end of the account code, so
program a “10” in the segment immediately after the last digit of the account code. If the
account code is 6 digits long, program all 6 segments. If this location is left unprogrammed,
account code 1 will be used when the second phone number is dialled.
LOCATION 8 - COMMUNICATOR FORMAT FOR PHONE N° 2 (1 segment, numerical data)
Location 8 contains the communicator format used to transmit to the receiver that is
connected to phone N°2. Consult the instruction manual for your central station receiver in
order to determine which format is compatible, and select from the 15 formats listed on page
33. If you require a format other than those listed, review the override options described in
Location 18 to create the appropriate format. In order to create a special format, a “15” must
be programmed in location 8, in addition to the entries in location 18. If this location contains
a “0”, format 1 will be used when phone N°2 is dialled.
NX-8-EUR Installation manual Page 38 02/07/06
To Next Page
Loading...
Need help?
General
