GE NetworX NX-8-EUR User Manual

Communicator codes for slow speed formats only
LOCATIONS 56-83 ARE ONLY USED WHEN REPORTING EVENTS TO A PAGER, OR WHEN USING A
SLOW FORMAT SUCH AS 4+2. WHEN USING CONTACT ID OR SIA, THERE IS NO NEED TO
PROGRAM THESE LOCATIONS.
LOCATION 56 - RESTORE COMMUNICATOR CODE, SLOW SPEED FORMATS ONLY (8 segments, numerical data)
Location 56 contains the event code for a zone “Restore” for a 4+2 and 3+1 format. For a 4+2
format, the digit programmed in this location will be sent as the tens digit of the restore event
code. The zone ID will always be reported as the ones digit of the zone number (e.g. zone 16 =
6, zone 45 = 5).
This location contains 8 segments. Any segment left as “0” will follow the segment 1 selection.
Segment 1
Partition 1 “Restore Code”
Segment 2
Partition 2 “Restore Code”
Segment 3
Partition 3 “Restore Code”
Segment 4
Partition 4 “Restore Code”
Segment 5
Partition 5 “Restore Code”
Segment 6
Partition 6 “Restore Code”
Segment 7
Partition 7 “Restore Code”
Segment 8
Partition 8 “Restore Code”
LOCATION 57 - BYPASS COMMUNICATOR CODE, SLOW SPEED FORMATS ONLY (8 segments, numerical data)
Location 57 contains the event code for a zone “Bypass” with a 4+2 and 3+1 format. For a 4+2
format, the digit programmed in this location will be sent as the tens digit of the bypass event
code. The zone ID will always be reported as the ones digit of the zone number (e.g. zone 16 =
6, zone 45 = 5).
This location contains 8 segments. Any segment left as “0” will follow the segment 1 selection.
Segment 1
Partition 1 “Bypass Code”
Segment 2
Partition 2 “Bypass Code”
Segment 3
Partition 3 “Bypass Code”
Segment 4
Partition 4 “Bypass Code”
Segment 5
Partition 5 “Bypass Code”
Segment 6
Partition 6 “Bypass Code”
Segment 7
Partition 7 “Bypass Code”
Segment 8
Partition 8 “Bypass Code”
NX-8-EUR Installation manual Page 62 02/07/06

GE NetworX NX-8-EUR Specifications

General

Brand	GE
Model	NetworX NX-8-EUR
Category	Control Panel
Language	English