GE NetworX NX-8-EUR User Manual

LOCATION 78 - CLOSING COMMUNICATOR CODE, SLOW SPEED FORMATS ONLY (8 segments, numerical data)
Location 78 contains the tens digit for a 4+2 and 3+1 format if “Closing Reporting” is enabled.
The ones digit is the ones digit of the user number that did the opening. If the user is greater
than 9, the numbers will begin repeating (e.g. code 6 = 6, code 45 = 5).
This location contains 8 segments. Any segment left as “0” will follow the segment 1 selection.
If you need to report openings and closings with a unique code per user, Contact ID or SIA
format must be used.
Segment 1
Closing code for partition 1
Segment 2
Closing code for partition 2
Segment 3
Closing code for partition 3
Segment 4
Closing code for partition 4
Segment 5
Closing code for partition 5
Segment 6
Closing code for partition 6
Segment 7
Closing code for partition 7
Segment 8
Closing code for partition 8
LOCATION 79 - AUTOTEST COMMUNICATOR CODE, SLOW SPEED FORMATS ONLY (2 segments, numerical data)
Location 79 contains the tens and ones digits for a 4+2 and 3+1 format that will be sent if
“Autotest” or “Manual Test” is enabled. Segment 1 contains the tens digit, and segment 2
contains the ones digit.
For a 3+1 format, only the segment 1 digit (tens) will be sent.
LOCATION 80 - RECENT CLOSING AND EXIT ERROR COMMUNICATOR CODE, SLOW SPEED FORMATS ONLY (2
segments, numerical data)
Location 80 contains the tens digit for a 4+2 and 3+1 format that will be sent if “Recent
Closing” and/or “Exit Error Reporting” is enabled. Segment 1 contains the tens digit for the
“Recent Closing Reporting”. Segment 2 contains the tens digit for the “Exit Error Reporting”.
The ones digit is the ones digit of the user number that did the opening. If the user is greater
than 9, the numbers will begin repeating (e.g. code 6 = 6, code 45 = 5).
If you need to report Recent Closings and Exit Errors with a unique code per user, Contact ID
or SIA format must be used.
LOCATION 81 - START PROGRAM AND END PROGRAM COMMUNICATOR CODES, SLOW SPEED FORMATS ONLY (4
segments, numerical data)
Location 81 contains the tens and ones digits for a 4+2 and 3+1 format that will be sent if
“Start / End Programming Reporting” is enabled. Segment 1 contains the tens digit of the
“Start Program Reporting”. Segment 2 contains the ones digit of the “Start Program Reporting”.
Segment 3 contains the tens digit of the “End Program Reporting”. Segment 4 contains the
ones digit of the “End Program Reporting”.
For a 3+1 format, only the segment 1 digit resp. segment 3 digit (tens) will be sent.
NX-8-EUR Installation manual Page 68 02/07/06

GE NetworX NX-8-EUR Specifications

General

Brand	GE
Model	NetworX NX-8-EUR
Category	Control Panel
Language	English