GE Optima XR220amx - Identification and Compliance Plates

Chapter 2: Safety and Regulatory
Optima XR220amx X-Ray System 54400222-1EN Rev 1 DRAFT 11092010 2-16
Operator Manual © 2010 General Electric Company. All rights reserved.
Identification and Compliance Plates
Product identification labels can be found on the system. The types of system identification compliance
plates are located in the table below.
Identification Plate
Figure 2-2 Typical identification plate
Figure 2-3 Typical identification plate
Indicates the collimator blades are open. The controlled blades are shown in
thicker lines.
Indicates the use of laser radiation.
Table 2-8 Collimator descriptions
Symbol Description
DRAFT REVIEW COPY
CTRL+SHIFT+F to search using Search Index (faster)