Energy Packs
24 PACSystems* Controllers Battery and Energy Pack Manual GFK-2741D
3.2.11 Diagnostics
3.2.11.1 System Version Information
The Controller’s web-based home page displays serial number and version information for the Base and Cap Pack.
For additional information, refer to the Controller user manual.
3.2.11.2 Status Information
The Energy Pack provides the following status information to the Controller, which it uses to generate fault and
status bit indications. For Controller fault and status bit details, refer to the Controller user manual.
The Energy Pack is charging; not yet fully charged.
A hardware fault exists in the Energy Pack.
The Energy Pack is near its end of life and should be replaced.
The Energy Pack is fully charged and is ready to support CPU operation.
3.2.11.3 Energy Pack LEDs
Details on the LED operation for this Energy Pack are listed in LED Indications.
3.2.12 Agency Certifications
The following table lists the standards to which the Energy Pack has been certified.
Agency Standard
or Marking
N.A. Safety for Information
Technology Equipment
Certification by Underwriter's Laboratories to UL 60950-
1and CSA 60950-1
N.A. Safety for Industrial
Control Equipment
Certification by Underwriter's Laboratories to UL 508 and
CSA C22.2 No 142 - M1987
Electromagnetic
Compatibility Directive
European EMC
Self-Declaration in accordance with European Directives;
Refer to Technical Support at http://www.ge-ip.com/ for EC
Declaration of Conformity
Note: The agency approvals listed above and on the Declaration of Conformities are believed to be accurate;
however, a product’s agency approvals should be verified by the marking on the unit itself.
3.3 PACSystems RX3i Energy Pack (IC695ACC400)
Refer to PACSystems* RX3i Energy Pack IC695ACC400 IPI, GFK-2724.
3.4 PACSystems RX3i Energy Pack (IC695ACC402)
Refer to PACSystems* RX3i Energy Pack IC695ACC402 Quick Start Guide, GFK-2939.
To Next Page
Loading...
Need help?
General
