GE PFDN445 - Page 36

'+'(#)$$'(,#8534B8A43
=BC0;;0C8>==BCAD2C8>=B
'+'($$'#!
#%(
Lay the chrome cover down on a soft,
protected, flat surface so that the inner part
faces upward (resting on the handle side).
Disassemble the door cap from the chrome
cover on the handle side by removing 2 screws
(#8 x 0.625″ tapping screws).
Door cap

Assemble the inner handle onto the opposite side
of the chrome cover, using 4 screws
(#8 x 0.625″ tapping screws).
'+'($$'#!
#%($#)
Pop the 2 handle caps out toward you and
reassemble on the opposite side of the chrome
cover, where you removed the outer handle.
Handle caps

Disassemble the outer handle from the inner
handle by removing 3 screws (#8 x 0.625″
tapping screws). Disassemble the inner handle
from the chrome cover by removing 4 screws
(#8 x 0.625″ tapping screws).
2 x D
Screws
Remove
4 x D screws
(Inner handle)
Replace
4 x D
screws
(Inner
handle)
Inner
handle
3 x D
Screws
(Outer
handle)
Inner
handle
