PT878 Quick Start Guide 17
July 2003
Changing the Measured Parameters
Once the PT878 is programmed, you can display the following
measurements on the screen:
• Velocity
• Volumetric
• Forward Totals
• Reverse Totals
• Power
• Energy
• Diagnostics
To enter the Measurement option:
1. Press
[SEL] from the Operate Mode window until you have
reached the desired measurement.
2. Press
[ENTER] to open the Display Menu. The screen appears
similar to Figure 6 below.
Figure 6: The Display Menu
2000/11/30 09:53 AM
4
Velocity, ft/s
0.00
32
Delta-T, ns
0.10
0.0
Volume, l/s
E0: No Errors
ABC.SIT
Signal, dB
Format View Measurement
To Next Page
Loading...
