GE RX3i PROFINET - Supported Modules, Power Supplies, and Backplanes

Chapter 1. Introduction
GFK-2737F December 2016 11
1.7 Supported Modules, Power Supplies and Backplanes
For an updated list of modules, power supplies and backplanes that can be used with an RX3i PROFINET
Scanner, refer to the most recent version of the PACSystems RX3i PROFINET Scanner Important Product
Information, GFK-2738. The list below was published in GFK-2738L (June 2016).
Catalog Number
Module Description
Distinguishing Classes
1
Discrete Input Modules
IC693ACC300
Input Simulator Module (8-pt & 16-pt operation)
8 in, 16 in
IC693MDL230
8-Circuit Input 120 Vac Isolated
8 in
IC693MDL231
8-Circuit Input 240 Vac Isolated
8 in
IC693MDL240
16-Circuit Input 120 Vac
16 in
IC693MDL241
16-Circuit Input 24 Vac / Vdc
16 in
IC693MDL250
16-Circuit Isolated Input 120 Vac, Input Filtering Off
16 in
IC693MDL250
16-Circuit Isolated Input 120 Vac, Input Filtering On
none
IC693MDL260
32-Circuit Input 120 Vac, Input Filtering Off
32 in
IC693MDL260
32-Circuit Input 120 Vac, Input Filtering On
32 in/out
IC693MDL632
8-Circuit Input 125 Vdc Positive / Negative Logic
8 in
IC693MDL634
8-Circuit Input 24 Vdc Positive / Negative Logic
8 in
IC693MDL635
16-Circuit Input 125 Vdc Positive / Negative Logic
16 in
IC693MDL645
16-Circuit Input 24 Vdc Positive / Negative Logic
16 in
IC693MDL646
16-Circuit Input 24 Vdc Positive / Negative Logic Fast
16 in
IC693MDL648
16-Circuit Input 48 Vdc Positive / Negative Logic Fast
16 in
IC693MDL654
32-Circuit Input 5/12 Vdc Positive / Negative Logic
32 in
IC693MDL655
32-Circuit Input 24 Vdc Positive / Negative Logic Fast
32 in
IC693MDL660
32-Circuit Input 24 Vdc Positive / Negative Logic, Input Filtering Off
32 in
IC693MDL660
32-Circuit Input 24 Vdc Positive / Negative Logic, Input Filtering On
32 in/out
IC694ACC300
Input Simulator Module (8-pt & 16-pt Mode)
8 in, 16 in
IC694MDL230
8-Circuit Input 120 Vac Isolated
8 in
IC694MDL231
8-Circuit Input 240 Vac Isolated
8 in
IC694MDL240
16-Circuit Input 120 Vac
16 in
IC694MDL241
16-Circuit Input 24 Vac / Vdc
16 in
1
The PNS001 cannot distinguish between modules within the same Distinguishing Class type. This means that any module
physically present that is within the same class as the one configured will not alert the user with a System Configuration
Mismatch fault on the Controller Fault Table. Refer to the section entitled CPU operation during System Configuration Mismatch
Faults in PACSystems RX7i and RX3i CPU Reference Manual, GFK-2222.