GE RX3i PROFINET - Chapter 5 Operations

73 pages

To Next Page

To Previous Page

GFK-2737F December 2016 51

Chapter 5 Operations

This chapter describes:

 Power-up

 I/O Scanning

 Hot Swap of I/O Modules

 Firmware Updates

Main Page

Default Chapter4
- Table of Contents4
Table of Figures7
Chapter 1 Introduction8
Revisions in this Manual10
Rx3I PROFINET Scanner Specifications11
Rx3I PROFINET Scanner Controls and Indicators12
- Figure 1: Front View IC695PNS00112
PROFINET Communications14
- Notes on Available PROFINET Controllers14
- Operations of the PROFINET Scanner15
PROFINET Redundant Media16
System Limits17
Supported Modules, Power Supplies and Backplanes18
Glossary23
Documentation25
Chapter 2 LED Operation and Connector Details26
Normal Operation of Individual Leds27
- Ok Led27
- Lan Led27
- Status LED27
- Conn Led27
- Port Leds28
- Active LED28
- Usb Led28
- Special LED Blink Patterns28
- Figure 3: IC695PNS001 Leds30
Ethernet Network Ports31
- Figure 4: Underside of IC695PNS001 Showing Ethernet Ports31
SD Card Slot32
USB Port33
Chapter 3 Installation34
Pre-Installation Check35
Installation in Hazardous Areas36
- ATEX Marking36
Module Installation37
- Power Requiremnents37
- Hot Insertion and Removal37
- Removing the Backplane Knockout37
- Figure 5: Rx3I Backplane Showing Removable Plastic Knockout37
- Module Installation38
- Module Removal38
- Figure 6: Install Module into Rx3I Backplane38
- Figure 7: Remove Module from Rx3I Backplane38
Replacing a PROFINET Scanner39
- Method 1 - Using the SD Card39
- Method 2 - Using the DCP Tool39
SFP Modules for Ethernet Ports40
External Switch VLAN Priority Settings40
Installing the USB Port Driver40
Firmware Updates40
Chapter 4 Configuration42
Configuration Overview43
- Basic Configuration Steps43
- Configuration Tool43
Adding an IO-Device to a PROFINET LAN44
- Adding an Rx3I PROFINET Scanner to the PROFINET LAN44
- Configuring an Rx3I PROFINET Scanner45
- Figure 8: Select System Redundancy Parameters in PME46
- Adding Rx3I Modules47
- Figure 9: Change Submodule List Produces List of Eligible SFP Modules47
- Figure 10: Analog Module with Configurable Parameters49
- Figure 11: Analog Module with Multiple Possible Option Settings50
- Support for Analog Modules with HART Features51
- Configuring Module Parameters51
Assigning Device Names55
- Transferring the Device Name with an SD Card55
After the Configuration Is Stored to the PROFINET Controller56
Chapter 5 Operations58
Power-Up59
I/O Scanning60
- PROFINET Scanner Status and Control Data60
- Data Coherency61
- Sampling Rate61
- Differences from Main (CPU) Rack61
- Output Control62
Hot Swap of I/O Modules63
Chapter 6 Diagnostics64
Configuration Faults65
Version Information66
Fatal Error Handling67
Connection Troubleshooting68
Appendix A PROFINET Specifications70
A-1 PROFINET Protocol Support70
A-2 Technical Data70
A-3 Limitations71
- A-3.1 Pacsystems Features71
- A-3.2 PROFINET Features71

GE RX3i PROFINET - Chapter 5 Operations

Table of Contents

Related product manuals