To arm motion sensors (level 3):
1. Press .
2. Press MOTION SENSORS ONLY (AWAY) (see Figure 3 on page 8).
3. If a code is required, enter your code when the keypad screen appears.
The panel speaks Motions On, starts an exit delay, and sounds exit beeps in
groups of three until the exit delay expires.
Note: Depending on your configuration, this option may not appear.
To arm doors, windows, and motion sensors (level 4):
1. Press
.
2. Press ARM ALL (AWAY) (see Figure 3 on page 8).
3. If a code is required, enter your code when the keypad screen appears.
The panel speaks Doors and Windows On, Motions On, starts an exit delay, and
sounds exit beeps in groups of four until the exit delay expires.
Unvacated premises
Unvacated premises is a feature that determines whether the system automatically
arms down to level 2 (doors and windows) if you arm the system to level 4 (doors,
windows, and motion sensors) without opening or closing a perimeter door (on), or
remains at the armed level chosen (off). This feature does not work from a key fob.
Autobypass must be on for this feature to work.
Ask your installer how this option is programmed.
Swinger shutdown
This setting determines if a sensor or zone will go into alarm only once during an
arming period (an active arming level) and will not be active again until the alarm is
canceled (Swinger Shutdown is enabled) or the sensor or zone will always be active
and will go into alarm multiple times during an arming period (an active arming level)
without canceling the alarm (Swinger Shutdown is disabled).
Simo
n XTi User Manual 9
To Next Page
Loading...
Need help?
General
