What to do if GE SimpliNano shows X against Wavelength calibration on initialisation screen?
If an 'X' appears against wavelength calibration on the initialisation screen, check that the sample beam is clear when the instrument is switched on.
What to do if GE SimpliNano Measuring Instruments fails to initialise – “cell holder obstructed UV” error message?
Ensure sample plates are clean.
What to do if GE SimpliNano shows Absorbance readings stable but incorrect?
Check pathlength calibration.
General| Brand | GE |
|---|---|
| Model | SimpliNano |
| Category | Measuring Instruments |
| Language | English |
Defines the range of instruments covered in the document.
Explains spectrophotometer usage and typical applications in laboratory settings.
Explains warning and caution symbols and their meanings for safe operation.
Outlines compliance with EU directives and relevant safety standards for equipment.
Details potential hazards like UV sources, high voltages, and hot surfaces for user safety.
Provides guidance on inspecting the instrument and site preparation for safe operation.
Covers switching on the instrument and selecting software modules for operation.
Details sample measurement using cuvettes, including zeroing and sample placement.
Explains sample measurement for SimpliNano and NanoVue Plus using sample ports or plates.
Describes cleaning procedures for cuvettes, sample ports, and plates after use.
Lists user-maintainable parts and procedures for different instrument models.
Step-by-step instructions for replacing the lamp in Novaspec III/Plus models.
Detailed guide for changing lamps in Ultrospec 8000/9000 series instruments.
Outlines steps to take in case of malfunction or hazard, including power disconnection.
Advises on decontamination before decommissioning and following local regulations.
Informs about hazardous substances within spectrophotometers and where to get information.
Guides on proper disposal of electrical waste, recommending separate collection.
To Next Page