GFK-1504N Chapter 2 Installation 2-25
Installing and Removing a Prewired Cable
To install a prewired connecting cable, place the cable connector over the
connector on the carrier and press downward until the latch engages the tab on
the connector.
To remove the cable, hold the cable connector and press up on the latch to
release the connector. When removing the cable, remember that operating
equipment may be very hot, especially at higher ambient temperatures. If the
equipment is hot, do not touch it directly.
DO NOT TOUCH exposed connector pins if the system is operating.
Connector Kit
A connector kit (part number IC200ACC304) is available for building custom
cables or for connecting wires directly from field devices. The kit includes two
connectors and covers, four screws, 27 small contacts, and 12 large contacts.
The following equipment is also required but not included in the kit:
Crimping Tools small contact Molex 11-01-0008
large contact Molex 11-01-0084
Extraction Tools small contact Molex 11-03-0002
large contact Molex 11-03-0006
Terminal Numbering
The following illustration displays the terminal assignments of the connector
pins as viewed from above.
To Next Page
Loading...
